Toro 269-H - Page 63

260 Series Tractor Service Manual 4 - 5
HYDRO-GEAR TRANSAXLE
3. Install the bolt, washer, and nut through the front
of the transaxle to the torque strap (Figure 132).
Figure 132
MVC-154X
4. Install the drive belt around the transaxle input
pulley, through the idler pulleys, and around the
engine drive pulley. Install the idler spring from
the torque strap to the idler bracket (Figure 133).
Figure 133
MVC-158X
5. Connect the damper cylinder to the control linkage
(Figure 134).
Figure 134
MVC-159X
6. If the tractor is equipped with cruise control, install
the cruise control bracket, making sure the
reverse operating rod fits through the hole
opposite the reverse plunger switch. Bolt the
cruise bracket to the side of the frame (Figure
135).
Figure 135
MVC-138X