HYDRO-GEAR TRANSAXLE
4 - 12 260 Series Tractor Service Manual
2. Remove the two steering tie rods from the
steering sector gear (Figure 148).
Figure 148
MVC-181X
3. Disconnect the brake rod at the transaxle by
removing the cotter pin, brake spring, and castle
nut (Figure 149).
Figure 149
MVC-193X
4. Remove the two carriage bolts and nuts holding
the right side footrest on (Figure 150).
Figure 150
MVC-195X
5. Remove the 2 roll pins that are located on the
brake cross shaft (Figure 151).
Figure 151
MVC-183X
To Next Page
Loading...
