HYDRO-GEAR TRANSAXLE
4 - 14 260 Series Tractor Service Manual
10. Make sure the belt is routed to the outside of the
brake rod (Figure 156).
Figure 156
MVC-190X
11. Connect the hydrostatic rod to the forward/reverse
hydro pedal (Figure 157).
Figure 157
MVC-191X
12. Install the two steering links to the steering sector
gear (Figure 158).
Figure 158
MVC-192X
13. Reconnect the brake rod at the transaxle. Install
the castle nut and spring (Figure 159). Before
installing the cotter pin, check the brakes, refer to
”Checking the Brake" on page 4 - 9.
Figure 159
MVC-193X
To Next Page
Loading...
