24
Maintenance
Service Interval Maintenance Procedure
After the first 10 hours • Check the power take-off belt tension.
• Check the fan and alternator belt tension.
• Change the transmission filter.
• Torque the wheel lug nuts.
After first 50 hours • Change the engine oil filter.
• Torque the engine head and check engine RPM.
Every 50 hours • Check the battery fluid level.
• Check the battery cable connections.
• Lubricate all grease fittings.
• Lubricate the brake cables.
• Check the cutting unit gear box oil level.
• Clean under the cutting unit belt covers.
• Check the cutting unit drive belt adjustment.
• Change the engine oil.
• Inspect the air filter and baffle
Every 100 hours • Change the engine oil filter.
• Check the electric clutch gap adjustment
• Check the power take off belt tension.
• Check the fan and alternator belt tension.
• Inspect the cooling system hoses.
Every 200 hours • Check rear wheel toe-in and steering linkage.
• Change the transmission filter.
• Torque the wheel lug nuts.
Every 400 hours • Service the air filter
• Drain and clean the fuel tank.
• Change the cutting unit’s gear box oil
• Change the fuel/water separator filter.
• Pack the rear wheel bearings.
• Coat the transmission bypass pins with grease
• Torque the head, adjust the valves and heck engine RPM.
Every 1000 hours or 2 • Replace moving hoses.
years, whichever • Replace safety switches.
occurs first • Flush and replace the coolant system fluid.
• Replace the hydraulic oil.
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule
To Next Page
Loading...
