Need help?Do you have a question about the Toro 30743 and is the answer not in the manual?
General| Model | 30743 |
|---|---|
| Category | Floor Machine |
| Voltage | 12 VDC |
| Power Source | Electric |
| Type | Scrubber |
Read and understand the manual, know controls, and stop quickly. Proper instruction is required.
Follow safe operating practices, especially on slopes, turns, and varying terrain to prevent loss of control.
Details brush filament, diameter, sweeping width, ground pressure adjustment, speed, hydraulic drive, wheels, and weight.
Lists available optional equipment such as steel brush elements and electric swivel options.
Guidance on determining left/right sides and pump mounting for different PTO shaft lengths.
Instructions for attaching the broom head pivot, connecting hydraulic hoses, and securing the swivel tube.
Steps to attach the actuator to the broom head frame and secure the shaft end to the tank mount.
Details on mounting the control box, routing wires, and connecting power to the instrument panel.
Procedure for positioning the broom, attaching the ball joint mount, and coupling PTO shafts.
Guidance on mounting the pump differently based on cutting decks to prevent PTO shaft separation.
Specifies 140 lbs of rear weight required for the Rotary Broom (Model No. 30743) on two-wheel drive units.
Specifies 70 lbs of rear weight required for the Rotary Broom (Model No. 30743) on four-wheel drive units.
Proper pressure ensures brush tip effectiveness. Measure sweeping path width (2-4 inches).
Adjust lift chain for 1-2 inch broom clearance in transport lift position, castors on ground.
Verify reservoir is filled with Mobil 424 hydraulic oil and check level in site glass.
Steps for lowering the broom, increasing engine speed, engaging PTO, and driving at a slow speed.
Instructions for setting broom angle straight, left, or right using manual or electric swivel.
Tips to extend brush life: avoid excessive pressure, keep brush level, and maintain appropriate ground speed.
Excessive ground speed causes side thrust and stress on bristles, leading to premature wear or damage.
Raise broom to transport position and drive slowly to allow curb or ramp to lift broom.
Lubricate nine fittings regularly with No. 2 general purpose lithium grease after 8 hours of operation.
Steps to disconnect the broom by removing pins, chains, and then backing the traction unit away.
Procedure for removing brush retainer plates, sliding old elements off, and installing new ones.
To Next Page