Toro 30873TE - Page 3

g021282
Figure2
1.Bolts6.Tubebracket
2.Chassisbracket
7.Pressurehose
3.Dividertube8.Up
4.Nut9.Forward
5.Clamp
3.Removetherearendofthepressurehosefrom
thettinginthehydraulicpump,andremovethe
pressurehose(Figure1andFigure2).
4.Temporarilycapthepumpandthedividertube.
Note:Discardtheoriginalpressurehose.
RemovingtheCrossTube
1.Alignthedrainpanbelowtherear-traction
manifold.
2.Removethetubenutforthecrosstubefromthe
ttingintherear-tractionmanifold(Figure1).
3.Removethetubenutfortheltertubefromthe
ttinginthecrosstube,andremovethecross
tube(Figure1).
Note:Discardthecrosstube.
4.Temporarilycapthettingintherear-traction
manifold.
RemovingtheTubeBracketand
theClamp
1.Removetheboltandthenutthatsecurethe
dividertubetothetubebracket,andremovethe
clamp(Figure2).
2.Removethe2boltsandthe2nutsthatsecure
thetubebrackettothechassisbracket(Figure
2).
Note:Discardthetubebracketandtheclamp.
RemovingtheDividerTube
1.Removethetubenutfortherear-tractiontube
fromthettingofthedividertube.
2.Removethetubenutofthedividertubefrom
theT-ttinginthefront-lefttractionmotor,and
removethetubefromthemachine(Figure1).
Note:Discardthedividertube.
3