Toro 38516 - Snowthrower Setup and Assembly; Verify Loose Parts Shipped; Folding and Unfolding the Handle

105-1981
Reorder part no. 105-3523
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Description
Qty.
Use
1.
No parts required
–
Unfold the handle.
Discharge chute
1
Chute handle
1
Phillips head screws
3
Washers
3
2.
Locknuts
3
Install the discharge chute.
1. Unfolding the Handle
1. Cut the plastic tie that secures the control cable to the
handle .
Note: Hold the cable taut to ensure that it sta ys
connected at the bottom.
2. Loosen the knobs , pull out the handle bolts , and rotate
the upper handle to the operating position ( Figure 3 ).
5