Figure 3
3. Hook the end of the control cable spring into the
bottom hole of the control bar ( Figure 4 ).
Figure 4
4. Fully inser t the handle bolts ( Figure 5 ).
Important: Ensur e that y ou do not pinch the
contr ol ca ble ( Figur e 5 ).
Figure 5
5. Tighten the knobs until they are sn ug .
6. Adjust the control cable . R efer to Adjusting the Control
Cable .
2. Installing the Discharge
Chute
Install the disc harg e c hute as sho wn ( Figure 6 ).
Figure 6
6
To Next Page
Loading...
