SCAMP MODELS
SELF PROPELLED
SERVICING AND ADJUSTMENTS
4.
With the control handle in “neutral” (free) posi-
6.
Secure upper and lower control rods together
tion as shown.
with the clamp screw as shown. This screw should
be tightened securely by hand.
5.
With the clutch arm resting on the handle and
wheel bracket as shown.
SAFETY WARNING: Improper tighten-
ing
of
clamp screw
on
control rod may
result in operator
loss
of
drive control
mechanism.
NOTE:
To
put mower in motion, pull
upward on control handle and hold in
drive position.
To
stop forward motion
of mower, release control handle.
Mower drive mechanism functions
only when the control handle is held
in
“DRIVE”
position.
19.42
SERVICE BULLETIN REFERENCES
1983
To Next Page
Loading...
