6.
Remove belt from driven pulley and slide shaft
assembly to the right. Remove belt from mower as
shown.
SCAMP MODELS
REPLACEMENT AND SERVICING
SELF-PROPELLED DRIVE BELT
SAFETY WARNING:
To
prevent start-
ing
of
engine, disconnect and remove
spark plug prior to removing the
engine.
3.
Remove three bolts securing engine to muffler
plate and remove engine.
NOTE:
Do
not remove muffler plate
from housing when removing engine.
4.
Remove engine and remove drive belt from drive
pulley.
SAFETY WARNING:
Do
not operate
mower with belt guard removed.
5.
Remove roll pin from left hand drive roller and
remove roller.
To Next Page
Loading...
