Toro 51480A - Replacing the String

6.Pullthestringsextendingfromthestringheadsothatthe
stringsreleasefromtheslotsinthespool.
7.Installthespoolretainerbypressingthetabsintotheslots
andpushingdownonthespooluntilthespoolretainerclicks
intoplace.
ReplacingtheString
Important:Useonly1.65mm(0.065inch)diameter
monolamentstring.Donotuseanyothergaugeortypeof
string,asthiscoulddamagethetrimmer.
1.Removethespool;refertoReplacingtheSpool(page8).
2.Removeanystringremainingonthespool.
3.Insertthestringintotheanchorholeintheupperpartof
thespool(Figure12).
g021146
Figure12
1.Slotinupperspoolange3.Slotinlowerspoolange
2.Hole
Note:Windthestringontothespoolinthedirection
shownbythearrowsonthespool.
Note:Thespoolcanacceptupto4.6m(15ft)ofstring.
4.Placethestringendsintheslotsontheupperspoolange,
leavingabout152mm(6inches)beyondtheslot.
Note:Donotoverllthespool.Afterwindingthestring,
thereshouldbeatleast6mm(1/4inch)betweeneachofthe
woundstringsandtheoutsideedgeofthespool.
5.Replacethespoolandthespoolretainer;refertoReplacing
theSpool(page8).
9