EN–10
Battery
Disposal
Battery
Removal
1. Lay unit on a flat table with screw heads in
housing facing upwards.
2. Remove one (1) self-tapping screw from
U-shaped handle. Remove two (2) screws and
nuts and five (5) self-tapping screws from the
power pack cover and lift off cover.
3. Lift the battery out of the power pack and
disconnect the black and red wires from the
battery terminals.
Disposing
of Battery
DO NOT PLACE USED BA
TTERIES IN YOUR
REGULAR TRASH!
THIS SEALED LEAD (ACID) BA
TTER
Y MUST
BE COLLECTED, RECYCLED OR DISPOSED
OF IN AN ENVIRONMENT
ALLY SOUND
MANNER.
The incineration, landfilling or mixing of sealed lead
(acid) batteries with the municipal solid waste stream
is
PROHIBITED BY LA
W in some areas.
Return this battery to a federal or state approved
sealed lead (acid) battery recycler. This may be where
you purchased the battery.
Contact your local waste management officials for
other information regarding the environmentally
sound collection, recycling and disposal of this
battery.
Maintenance
POTENTIAL HAZARD
• When trimmer is in operation, the cutting
head is rotating.
WHAT CAN HAPPEN
• Contact with rotating cutting head could
cause personal injury.
HOW TO AV
OID THE HAZARD
•
Always be sur
e cutting head has completely
stopped rotating before attempting any
maintenance.
1. To keep the exterior clean, just wipe it off with a
damp cloth. Never hose it down.
2. Wipe or scrape clean the drum and spool area
any time there is an accumulation of dirt or
cuttings.
3. Check and tighten all fasteners. If any part is
damaged or lost, repair or replace it.
4. Make sure battery is fully charged and charger is
unplugged from trimmer before storing.
5. Store trimmer in a cool, dry place. Do not store
trimmer in direct sunlight or near a furnace.
Storing trimmer in a warm area will decrease life
of battery. If trimmer must be stored in a warm
area, charge the battery for 24 hours every 2-3
months.
6. Any other servicing should be performed by an
authorized Toro Service Dealer.
To Next Page
Loading...
