Need help?Do you have a question about the Toro 580-D BOXER ROPS and is the answer not in the manual?
General| Brand | Toro |
|---|---|
| Model | 580-D BOXER ROPS |
| Category | Lawn Mower Accessories |
| Language | English |
Single front bracket for ROPS mounting.
Left and Right rear brackets for ROPS mounting.
Two cab lift brackets for lifting the ROPS assembly.
Two 3/8" black snap caps for covering holes.
One step weldment component for the ROPS.
Includes hex bolts, nuts, flat steel washers, rubber flat washers, and lock washers.
Includes hex bolts, flat steel washers, and lock washers for mounting.
Includes hex bolts, nuts, flat steel washers, and lock washers.
Two 3/8" x 1/2" flange bolts for specific connections.
Torque values for 5/8", 3/4", and 7/16" hardware are provided for proper installation.
Steps for preparing and attaching the front bracket to the platform.
Procedure for sliding and loosely bolting the rear brackets into place.
Instructions for attaching lift brackets, hoisting the cab, and placing it onto isolators.
Guidance on torquing all mounting bolts, including specific spacing for rubber isolated mounts.
Removal of lift brackets and installation of snap caps into holes.
To Next Page