Toro 72108 - Battery Water and Electrolyte Checks; Adding Water to the Battery; Checking Electrolyte Level

Maintenance
32
Installing the Bulb
1. The bulb has metal pins on the side of its base.
Align the pins with the slots in the bulb holder
and insert the base into the holder (Fig. 36).
Push and rotate the bulb clockwise until it stops.
1
2
3
4
2
4
Figure 36
1. Bulb
2. Metal
pins
3. Bulb holder
4. Slots
2. The bulb holder has two tabs (Fig. 35). Align the
tabs with the slots in the reflector, insert the bulb
holder into the reflector and rotate it 1/4 turn
clockwise until it stops.
3. Push the wire connectors onto the terminals on
the bulb holder.