Toro 74010HD - Page 30

Adjusting the Height of Cut
For Machines with an Electric
Deck Lift
1. Push up on the deck-lift switch ( Figure 32 ).
g332765
Figure 32
1. Push up to raise the deck. 2. Push down to lower the
deck.
2. Select a hole in the height-of-cut bracket
corresponding to the height of cut desired, and
insert the pin ( Figure 33 ).
3. Push down on the deck-lift switch until the
height-of-cut linkage slightly contacts the
height-of-cut pin ( Figure 33 ).
Note: T oo much contact between the
height-of-cut linkage and height-of-cut pin can
negatively af fect the mower deck height of cut
and leveling.
g361935
Figure 33
1. Height-of-cut pin 3. Height-of-cut bracket
2. Height-of-cut linkage
Important: T ransporting the machine
without the deck resting on the height-of-cut
pin will cause unnecessary damage to the
deck lift actuator .
30