EasyManua.ls Logo

Toro 74024 - User Manual

Toro 74024
80 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Form No. 3466-237 Rev A
Z Master
®
4000 Series Riding
Mower
W ith 48in, 60in, or 72in TURBO FORCE
®
Mower
Model No. 74000 —Serial No. 415400000 and Up
Model No. 74000T A —Serial No. 415400000 and Up
Model No. 74004 —Serial No. 415400000 and Up
Model No. 74015 —Serial No. 415400000 and Up
Model No. 74020 —Serial No. 415400000 and Up
Model No. 74022 —Serial No. 415400000 and Up
Model No. 74024 —Serial No. 400000000 and Up
Model No. 74035 —Serial No. 415400000 and Up
Register at www .T oro.com.
Original Instructions (EN)
*3466-237*

Table of Contents

Questions and Answers

  • M
    mitchellangelaSep 22, 2025
    Why Toro Lawn Mower vibrates abnormally?
    • S
      Sheila GonzalezSep 22, 2025
      If your Toro Lawn Mower is vibrating abnormally, the cutting blade(s) may be bent or unbalanced, so install new cutting blade(s). Check if the blade mounting bolt is loose and tighten it. Also, ensure the engine mounting bolts are tightened. Inspect the engine pulley, idler pulley, or blade pulley for looseness and tighten the appropriate pulley, checking that idler springs are not over stretched. If the engine pulley is damaged, replace it. A bent blade spindle should also be replaced. Finally, check the motor mount for looseness or wear and inspect the mounting bolts.
  • S
    Sarah JonesAug 26, 2025
    What to do if Toro 74024 Lawn Mower starter does not crank?
    • C
      Cristian FloydAug 26, 2025
      If the starter on your Toro Lawn Mower doesn't crank, it could be due to several reasons. First, ensure the blade control switch (PTO) is disengaged. Also, the parking brake must be engaged, so move the motion control levers to the neutral lock (Park) position. A dead battery can also prevent cranking, so charge it. Check the electrical connections for good contact, as corrosion or looseness can be the issue. A worn or damaged switch or a blown fuse can also be culprits; test and replace the faulty switch or replace the fuse accordingly.
  • J
    Jasmin ChandlerAug 27, 2025
    How to fix uneven cutting height on my Toro Lawn Mower?
    • R
      rachel80Aug 27, 2025
      Uneven cutting height on your Toro Lawn Mower may be due to: * Dull blade(s): Sharpen the blade(s). * Bent cutting blade(s): Install a new cutting blade(s). * Mower not level: Level the mower from side-to-side and front-to-rear. * Incorrect anti-scalp roller setting: Adjust the anti-scalp wheel height. * Dirty mower deck underside: Clean the underside of the mower deck. * Incorrect tire pressure: Adjust the tire pressure.
  • H
    Herbert RichardsonAug 28, 2025
    Why Toro Lawn Mower engine loses power?
    • T
      Thomas LawsonAug 28, 2025
      Your Toro Lawn Mower engine may lose power if the engine load is excessive; reduce the ground speed or raise the height-of-cut. A dirty air cleaner can also cause this, so clean or replace the air cleaner element. Check the oil level in the crankcase and add oil if it's low. Obstructions in the cooling fins and air passages above the engine can lead to power loss, so remove any obstructions and thoroughly clean these areas. A failed ignition coil, a plugged fuel tank vent system, a dirty fuel filter, or dirt/water/stale fuel in the fuel system can also be responsible. Address these issues by replacing the coil, inspecting and repairing the vent system, replacing the fuel filter, or cleaning and flushing the fuel system.
  • J
    Judith WhiteSep 23, 2025
    What to do if my Toro Lawn Mower starter does not crank?
    • J
      Joseph HaydenSep 23, 2025
      If the starter on your Toro Lawn Mower doesn't crank, check these items: * Ensure the blade-control switch is disengaged. * Confirm the parking brake is engaged. * Make sure the motion-control levers are in the NEUTRAL-LOCK position. * Ensure you are sitting in the operator’s seat. * Charge the battery if it's dead. * Check the electrical connections for good contact and replace the fuse if it is blown.
  • S
    sgarnerNov 25, 2025
    Why won't my Toro 74024 engine start?
    • T
      tbridgesNov 25, 2025
      Several factors can prevent your Toro Lawn Mower engine from starting. The fuel tank might be empty, so fill it. The fuel-shutoff valve could be closed, so open it. The oil level in the crankcase may be low, so add oil. Ensure the throttle is midway between the slow and fast positions. Other potential causes include a dirty fuel filter (replace it) or a dirty air cleaner (clean or replace it). Also, check the spark plug wire connection, and adjust or replace the spark plug if it is fouled or improperly gapped. If the seat switch is not functioning properly, check the seat-switch indicator and replace the seat if necessary. For corroded, loose, or damaged electrical connections, check the electrical connections for good contact. Clean the connector terminals thoroughly with electrical-conta...
  • J
    jillbowmanSep 12, 2025
    Why won't my Toro Lawn Mower drive?
    • P
      Pamela MartinSep 12, 2025
      If your Toro Lawn Mower isn't driving, consider these possibilities: * Bypass valves are not closed tight: Tighten the bypass valves. * Pump belt is worn, loose, or broken: Change the belt. * Pump belt is off a pulley: Change the belt. * Idler spring is broken or missing: Replace the spring. * Hydraulic fluid level is low or too hot: Add hydraulic fluid to the reservoirs or let it cool down.
  • R
    Raymond HernandezSep 12, 2025
    Why aren't the blades rotating on my Toro 74024?
    • J
      jean57Sep 12, 2025
      If the blades on your Toro Lawn Mower aren't rotating, check: * Worn, loose, or broken drive belt: Install a new drive belt. * Drive belt off the pulley: Install the drive belt and check the adjusting shafts and belt guides for the correct position. * Worn, loose, or broken mower belt: Install a new mower belt.
  • D
    Donald KimSep 5, 2025
    Why is my Toro 74024 not moving?
    • N
      nancyjensenSep 5, 2025
      If your Toro Lawn Mower isn't driving, check the following: * Ensure the bypass valves are closed tight; tighten the bypass valves. * If the pump belt is worn, loose, or broken, replace the belt. * If the pump belt is off a pulley, change the belt. * Replace the spring if the idler spring is broken or missing. * If the hydraulic fluid level is low or too hot, add hydraulic fluid to the reservoirs or let it cool down.
  • D
    Drew BrownSep 3, 2025
    What to do if the blades on my Toro 74024 Lawn Mower won't rotate?
    • N
      Nichole JensenSep 3, 2025
      If the blades on your Toro Lawn Mower don't rotate, first check the drive belt; if it's worn, loose, or broken, install a new one. Also, ensure the drive belt is properly on the pulley, and check the adjusting shafts and belt guides for the correct position. If the power takeoff (PTO) switch or PTO clutch is faulty, or the mower belt is worn, loose, or broken, contact an Authorized Service Dealer.

Toro 74024 Specifications

General IconGeneral
Model74024
Deck MaterialSteel
Start TypeRecoil
Mulching CapabilityYes
Bagging CapabilityYes
Side Discharge CapabilityYes
Cutting Width22 inches
Drive SystemRear Wheel Drive
Weight80 lbs
Wheel Size (Front)8 inches
Wheel Size (Rear)11 inches
EngineBriggs & Stratton®
Fuel Capacity1.0 qt (0.95 L)
Fuel Tank Capacity1.0 qt (0.95 L)

Related product manuals