Toro 74024 User Manual

6. Slowly pour approximately 80% of the specied
oil into the ller tube and slowly add the
additional oil to bring it to the Full mark ( Figure
63 ).
g194610
Figure 63
7. Start the engine and drive to a at area.
8. Check the oil level again.
Changing the Engine-Oil Filter
1. Drain the oil from the engine; refer to Changing
the Engine Oil ( page 49 ) .
2. Change the engine-oil lter ( Figure 64 ).
g008804
g027477
Figure 64
Note: Ensure that the oil-lter gasket touches
the engine, and then turn the oil lter an extra
3/4 turn.
3. Fill the crankcase with the proper type of new
oil; refer to Engine-Oil Specications ( page 48 ) .
Servicing the Spark Plug(s)
Service Interval : Every 200 hours —For Kohler
Engines—check the spark plug(s).
Every 500 hours —For Kohler Engines—replace
the spark plug(s).
T ype: Champion XC12YC
Air Gap: 0.76 mm (0.030 inch)
50

Toro 74024 Specifications

General

Model	74024
Deck Material	Steel
Start Type	Recoil
Mulching Capability	Yes
Bagging Capability	Yes
Side Discharge Capability	Yes
Cutting Width	22 inches
Drive System	Rear Wheel Drive
Weight	80 lbs
Wheel Size (Front)	8 inches
Wheel Size (Rear)	11 inches
Engine	Briggs & Stratton®
Fuel Capacity	1.0 qt (0.95 L)
Fuel Tank Capacity	1.0 qt (0.95 L)