Toro 74246 - Maintenance; Recommended Maintenance Schedule

29
Maintenance
Recommended Maintenance Schedule
Maintenance Service
Interval
Maintenance Procedure
After first 5 hours
• Hydraulic fluid—check level
• Hydraulic filter—change
Each Use
• Oil—check level
• Safety System—check
• Mower Housing—clean
• Engine air intake—clean
1
Every 8 Hours • Cutting Blades—check
Every 25 Hours
• Idler arm—grease
• Traction belt idler arm—grease
• Brake lever—grease
• Mower support arms—grease
• Linkage bushings—oil
1
• Hydraulic fluid—check level
• Battery—check electrolyte
• Blade Spindle Bearings—grease
Every 50 Hours
• Belts—adjust tension
• Belts—check for wear/cracks
• Tires—check pressure
Every 100 Hours
• Engine Oil—change
1
• Hydraulic lines—check
• Engine Cooling System—clean
1
Every 200 Hours
• Oil Filter—change (200 hours or every other oil change)
1
• Hydraulic filter—change
• Spark Plug(s)—check
• Fuel Filter—replace
• Brake pivot—grease
Every 250 Hours
• Replace or clean primary air cleaner filter
1
• Safety air cleaner
1
— check
Every 500 Hours or at
Storage
• Caster Pivot— adjustment
• Wheel Hub Slotted Nut— adjustment
Every 600 Hours or at
Storage
• Safety air cleaner
1
— replace
Before Storage Service
• Battery–charge, Disconnect cables
• Gasoline—drain
• Chipped Surfaces—paint
• Perform all maintenance procedures listed above before storage
1
More often in dusty, dirty conditions