Toro 74253CP - Controls System Maintenance; Adjusting the Control Handle Neutral Position

Note:RemovethePTOdrivebeltrstifthepump
drivebeltneedstobereplaced.
1.Tilttheseatforwardandremovethefrontengine
panel.
2.RemovethePTOdrivebelt.
3.Removethespringfromtheidlerarm(Figure66).
4.Installthenewbeltaroundtheengineandhydraulic
pumppulley(Figure66).
5.InstallthePTOdrivebelt.
6.Installthespringtotheidlerarm(Figure66).
Figure66
1.Clutch
3.Pumpdrivebelt
2.Springloadedidlerpulley4.Spring
ControlsSystem
Maintenance
AdjustingtheControlHandle
NeutralPosition
Ifmotioncontrolleversdonotalign,ormoveeasilyinto
theconsolenotch,adjustmentisrequired.Adjusteach
lever,springandrodseparately.
Note:Motioncontrolleversmustbeinstalledcorrectly.
SeeInstallingtheMotionControlLeversinthesetup
instructions.
1.DisengagethePTO,movethemotioncontrollevers
totheneutrallockedpositionandsettheparking
brake.
2.Stoptheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
3.Unlatchtheseatandtilttheseatforward.
4.Beginwitheithertheleftorrightmotioncontrol
lever.
5.Movethelevertotheneutralpositionbutnotlocked
(Figure67).
6.Pulltheleverbackuntiltheclevispin(onarm
belowpivotshaft)contactstheendoftheslot(just
beginningtoputpressureonthespring)(Figure67).
7.Checkwherethecontrolleverisrelativetonotchin
console(Figure67).Itshouldbecenteredallowing
levertopivotoutwardtotheneutrallockposition.
Figure67
1.Neutrallockedposition3.Neutralposition
2.Controllever
8.Ifadjustmentisneeded,loosenthenutandjamnut
againsttheyoke(Figure68).
47