Toro 74295 - Adjusting the Anti-Scalp Rollers

Figure22
1.Heightofcutlever
2.Pin
2.Toadjust,removethepinfromtheheight-of-cut
bracket(Figure22).
3.Selectaholeintheheight-of-cutbracket
correspondingtotheheight-of-cutdesiredand,
insertthepin(
Figure22).
4.Movethelevertotheselectedheight.
AdjustingtheAnti-Scalp
Rollers
Wheneveryouchangetheheight-of-cut,itis
recommendedtoadjusttheheightoftheanti-scalp
rollers.
AdjustingtheOuterRoller
1.DisengagethePTO,movethemotioncontrollevers
totheneutrallockedposition,andsettheparking
brake.
2.Stoptheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
3.Afteradjustingtheheight-of-cut,removetheange
nut,bushing,spacer,andbolt(
Figure23).
Figure23
1.Outerroller
4.Bolt
2.Spacer
5.Nut
3.Bushing
4.Selectaholesothattheouterrollerispositioned
tothenearestcorrespondingheight-of-cutdesired
(
Figure23).
5.Installtheouterroller,bushing,spacer,bolt,and
nut(Figure23).
6.Torquetheboltto40to45ft-lb(54to61N⋅m).
AdjustingtheCenterRollers
1.DisengagethePTO,movethemotioncontrollevers
totheneutrallockedposition,andsettheparking
brake.
2.Stoptheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
3.Afteradjustingtheheight-of-cut,removetheange
nut,bushing,andbolt(
Figure24).
22