Toro 74295 - Controls System Maintenance; Adjusting the Control Handle Neutral Position

Figure62
3.Installnewbeltaroundengineandhydropump
pulleys(Figure62).
4.Pullspringloadedidlerdownandalignbelow
tractionbelt.Releasethepressureonthespring
loadedidler(
Figure62).
ControlsSystem
Maintenance
AdjustingtheControlHandle
NeutralPosition
Ifmotioncontrolleversdonotalign,ormoveeasilyinto
theconsolenotch,adjustmentisrequired.Adjusteach
lever,springandrodseparately.
Note:Motioncontrolleversmustbeinstalledcorrectly.
SeeInstallingtheMotionControlLeversinthesetup
instructions.
1.DisengagethePTO,movethemotioncontrollevers
totheneutrallockedpositionandsettheparking
brake.
2.Stoptheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
3.Unlatchtheseatandtilttheseatforward.
4.Beginwitheithertheleftorrightmotioncontrol
lever.
5.Movethelevertotheneutralpositionbutnotlocked
(
Figure63).
Figure63
1.Neutrallockedposition3.Neutralposition
2.Controllever
6.Pulltheleverbackuntilthepin(onarmbelowpivot
shaft)contactstheendoftheslot(justbeginningto
putpressureonthespring)(Figure63).
7.Checkwherethecontrolleverisrelativetonotchin
console(Figure63).Itshouldbecenteredallowing
levertopivotoutwardtotheneutrallockposition.
8.Ifadjustmentisneeded,loosenthenutandjamnut
againsttheyoke(Figure64).
44