g020563
Figure 6
1. Safety-interlock indicators
2. Hopper up
3. Hour/V oltage display
4. Low-voltage indicator light
Battery-Indicator Light
If you turn the key switch to the O N position for a
few seconds, the battery voltage displays in the area
where the hours are normally displayed.
The battery light turns on when the key switch is
turned on and when the charge is below the correct
operating level ( Figure 6 ).
Safety-Interlock Indicators
There are symbols on the hour meter that indicate
with a black triangle that the interlock component is
positioned correctly ( Figure 6 ).
Engine-Oil-T emperature Light and
Buzzer
The engine-oil-temperature light monitors the
temperature of the engine oil. An illuminated
engine-oil-temperature light and intermittent buzzing
sound signals that the engine is overheating.
Electronic-Control Unit
Malfunction-Indicator Light
EFI Machines Only
The electronic-control unit (ECU) continuously
monitors the operation of the EFI system.
If a problem or fault within the system is detected, the
malfunction-indicator light (MIL) illuminates.
The MIL is the red light located in the right console
panel.
Once the MIL illuminates, make initial troubleshooting
checks; refer to the MIL section under T roubleshooting
( page 63 ) .
If these checks do not correct the problem, further
diagnosis and servicing by an Authorized Service
Dealer is necessary .
Motion-Control Levers
Use the motion-control levers to drive the machine
forward, reverse, and turn either direction ( Figure 4 ).
Parking-Brake Lever
Whenever you shut of f the engine, engage the parking
brake to prevent accidental movement of the machine.
Fuel-Shutoff V alve
Close the fuel-shutof f valve when transporting or
storing the machine.
14
To Next Page
Loading...
