To Next PageTo Next PageHow to fix uneven cutting height on my Toro 74314 Lawn Mower?
To address an uneven cutting height with your Toro Lawn Mower, begin by sharpening the blade(s) or installing new cutting blade(s). Level the mower deck from side-to-side and front-to-rear, and clean the underside of the mower. Adjust the tire pressure in the drive tires, position the spacers under hairpin cotters, and replace blades/spindles, checking for damage to the mower deck.
What to do if the blades do not rotate on my Toro 74314 Lawn Mower?
If the blades on your Toro Lawn Mower do not rotate, check the belt tension or replace the belt. Also, connect the PTO shaft and check the belt for damage. Install the belt and check adjusting shafts and belt guides for correct position.
What to do if my Toro Lawn Mower engine does not start, starts hard, or fails to keep running?
If your Toro Lawn Mower engine is having trouble starting or staying running, you can try the following: Fill the fuel tank, open the fuel-shutoff valve, and add oil to the crankcase. Ensure that the throttle control is midway between the slow and fast positions and replace the fuel filter. Also, clean or replace the air-cleaner element, check the seat-switch indicator (replacing the seat if necessary), check the electrical connections for good contact by cleaning the connector terminals thoroughly with electrical-contact cleaner and applying dielectric grease, and adjust or replace the spark plug, checking the spark-plug wire connection.
Why does my Toro Lawn Mower engine loses power?
If your Toro Lawn Mower engine is losing power, consider these possible causes. The engine load might be excessive, so try reducing the ground speed. A dirty air cleaner can also cause power loss, so clean it. Additionally, check the oil level in the crankcase and add oil if it's low. Make sure the cooling fins and air passages above the engine are free of obstructions. Clean or replace the fuel cap if the vent hole is plugged, and replace the fuel filter if it's dirty.
How to fix uneven cutting height with my Toro 74314?
If your Toro Lawn Mower is producing an uneven cutting height, there are several things you can check. First, ensure that the blade(s) is/are sharp; sharpen them if needed. If the cutting blade(s) is/are bent, install new ones. Make sure the mower deck is level from side-to-side and front-to-rear. Clean the underside of the mower if it's dirty. Adjust the tire pressure in the drive tires. Position the spacers under hairpins.
Why does my Toro Lawn Mower engine lose power?
Loss of power in your Toro Lawn Mower engine can occur due to several reasons. The engine load might be excessive, or the air cleaner could be dirty. Low oil level in the crankcase, plugged cooling fins and air passages, or a blocked vent hole in the fuel cap can also cause power loss. Additionally, check for dirt in the fuel filter, or dirt, water, or stale fuel in the fuel system. To resolve some of these issues, reduce the ground speed, clean the air-cleaner element, add oil to the crankcase, remove the obstruction from the cooling fins and the air passages, clean or replace the fuel cap, and replace the fuel filter. In case of dirt, water, or stale fuel in the fuel system, contact an Authorized Service Dealer.
Why aren't the blades rotating on my Toro 74314?
If the blades on your Toro Lawn Mower aren't rotating, the PTO belt may be worn, loose, or broken. Check if the PTO shaft is disconnected or if the PTO belt is off the pulley. To resolve some of these issues, check the belt tension or replace the belt, connect the PTO shaft, and check the belt for damage. Install the belt and check adjusting shafts and belt guides for correct position.
What to do if my Toro Lawn Mower engine loses power?
If your Toro Lawn Mower engine is losing power, first reduce the ground speed. Then, clean the air-cleaner element and add oil to the crankcase. Also, remove any obstructions from the cooling fins and air passages. Clean or replace the fuel cap and replace the fuel filter. If the problem continues, contact an Authorized Service Dealer.
What to do if Toro 74314 Lawn Mower engine loses power?
If your Toro Lawn Mower engine loses power, several factors could be responsible. Start by reducing the ground speed if the engine load is excessive. Check if the air cleaner is dirty and clean it if necessary. Make sure that the oil level in the crankcase is at the correct level. Also, ensure that the cooling fins and air passages are free from obstructions. Clean or replace the fuel cap if the vent hole is plugged. Replace the fuel filter if it is dirty. For issues related to dirt, water, or stale fuel in the fuel system, it is recommended to contact an Authorized Service Dealer.
Why is my Toro Lawn Mower engine losing power?
If your engine loses power, it could be due to several reasons. Firstly, the engine load might be excessive, so try reducing the ground speed. A dirty air cleaner can also cause power loss, so clean the air-cleaner element. Check the oil level in the crankcase and add oil if it's low. Make sure that the cooling fins and the air passages above the engine are not plugged, and clean or replace the fuel cap if the vent hole is plugged. Replace the fuel filter if it's dirty.
General| Model | 74314 |
|---|---|
| Deck Material | Steel |
| Cutting Width | 22 inches |
| Drive Type | Self-propelled |
| Drive System | Personal Pace |
| Oil Capacity | 20 oz |
