Toro 74449 - Positioning the Seat; Unlatching the Seat

2.Stoptheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
3.Afteradjustingtheheight-of-cut,adjusttherollers
byremovingtheangenut,bushing,spacer,and
bolt(Figure19,Figure20andFigure45).
Note:Thetwomiddlerollerswillnothaveaspacer
(Figure20).
4.Selectaholesotheanti-scalprollerispositionedto
thenearestcorrespondingheight-of-cutdesired.
5.Installtheangenutbushing,spacer,andbolt.
Torqueto40-45ft-lb(54-61N•m)(Figure19,
Figure20andFigure45).
6.Repeatthisadjustmentontheotheranti-scalp
rollers.
Figure19
1.Anti-scalproller4.FlangeNut
2.Spacer
5.Bolt
3.Bushing
Figure20
1.Anti-scalproller3.FlangeNut
2.Bushing4.Bolt
PositioningtheSeat
Theseatcanmoveforwardandbackward.Positionthe
seatwhereyouhavethebestcontrolofthemachine
andaremostcomfortable.
Important:Toadjust,movetheleversidewaysto
unlockseat(Figure21).
Slidetheseattothedesiredpositionandreleaselever
tolockinposition.
Figure21
1.Adjustmentlever
UnlatchingtheSeat
Pushtheseatlatchrearwardtounlatchtheseat.
Thiswillallowaccesstothemachineundertheseat
(Figure22).
20