Toro 74901 Z Master 5000 - Height of Cut Adjustment; Height of Cut Pin Adjustment; Adjusting the Anti-Scalp Rollers; Anti-Scalp Roller Adjustment

AdjustingtheHeight-of-CutPin
Theheight-of-cutisadjustedfrom1to5-1/2inches
(25to140mm)in1/4inch(6mm)incrementsbyrelocating
theclevispinintodifferentholelocations.
1.Movethetransportlocktothelockposition.
2.Pushonthedeckliftpedalwithyourfootand
raisethemowerdecktothetransportposition(also
the5-1/2inch(140mm)cuttingheightposition)
(
Figure27).
3.Toadjust,rotatethepin90degreesandremovethepin
fromtheheight-of-cutbracket(Figure27).
4.Selectaholeintheheight-of-cutbracketcorresponding
totheheight-of-cutdesiredand,insertthepin
(Figure27).
5.Pushonthedecklift,pullbackonthetransportlock,
andslowlylowerthemowerdeck.
1
3
2
G017027
Figure27
1.Deckliftpedal
3.Transportlock
2.Cutofheightpin
AdjustingtheAnti-Scalp
Rollers
Wheneveryouchangetheheight-of-cut,itisrecommended
toadjusttheheightoftheanti-scalprollers.
1.Disengagethebladecontrolswitch(PTO),movethe
motioncontrolleverstotheneutrallockedposition
andsettheparkingbrake.
2.Stoptheengine,removethekey,andwaitforallmoving
partstostopbeforeleavingtheoperatingposition.
Figure28
1.Anti-scalproller4.FlangeNut
2.Spacer
5.Bolt
3.Bushing
Figure29
1.Anti-scalproller3.FlangeNut
2.Bushing4.Bolt
Figure30
1.Anti-scalproller4.FlangeNut
2.Spacer
5.Bolt
3.Bushing
23