General T roubleshooting (continued)
Problem
Possible Cause Corrective Action
There is a low voltage supply at the
clutch.
Check the coil resistance, battery
charge, charging system, and wiring
connections and replace parts if
necessary .
The coil is damaged. Replace the clutch.
The current supply is inadequate. Repair or replace the clutch lead wire or
electrical system. Clean the connector
contacts.
The rotor/armature air gap is too large.
Replace the clutch.
The clutch does not engage.
The blade control switch (PT O) is faulty . Replace the blade control switch (PT O).
2000 Series Z MASTER®Service Manual Page 3–5
T roubleshooting: General T roubleshooting
3460-328 Rev A
To Next Page
Loading...
