Toro 79412 - Installing the Attachment Mount; Parts Needed for Mount Installation; Stabilizer Bracket and Pivot Frame Installation

1
PreparingtheMachine
NoPartsRequired
Procedure
1.Parkthemachineonalevelsurface.
2.Engagetheparkingbrake.
3.Shutofftheengineandremovethekey.
2
PreparingtheMachines
equippedwithMyRide
NoPartsRequired
Procedure
Removetheboltssecuringtheguardsonthesides
oftheframe.
Removetheguardsonbothsidesoftheframe.Retain
alloftheparts.
g308507
Figure3
3
InstallingtheWeights
Partsneededforthisprocedure:
4
Bolt(3/8x1inch)
6
Locknut(3/8inch)
1
Leftweight-mountingbracket
1Rightweight-mountingbracket
2Washer
2
Bolt(5/8x2-3/4inches)
6
Suitcaseweight
Procedure
CAUTION
Thebaggerchangestheweightdistributionof
themachine.Operatingthemachinewithout
thefrontweightsmaycauseanunstable
condition,whichcouldresultinalossof
control.
Ensurethefrontweightsareproperlyinstalled
beforeoperatingthemachinewiththebagger
attachment.
1.Installtheweight-mountingbracketstotheunder
sideoftheframeusing2bolts(3/8x1inch),
and2locknuts(3/8inch)asshowninFigure4.
2.Installthesuitcaseweightstotheweight
mountingbracketsusing2bolts(5/8x2-3/4
inches),2washers,and2locknuts(3/8inch)
asshowninFigure5.
3.Onceyouhaveinstalledalltheweightsand
brackets,ensurethatallthefastenersaretight.
Tightenasnecessary.
Important:Wheneveryouremovethe
baggerattachment,remembertoremovethe
frontweightstoreturntheproperstability
tothemachine.
6