Figure 13
1. Mount plate 2. Receiver plate
5. Raise the loader ar ms while tilting bac k the
mount plate at the same time .
Important: T he attachment should be
raised enough to clear the g r ound, and the
mount plate should be tilted all the w ay
back.
6. Stop the engine .
7. Eng ag e the quic k attac h pins , ensuring that
they are fully seated in the mount plate
( Figure 14 ).
Important: If the pins do not r otate to
the enga ged position, the mount plate
is not full y aligned with the holes in the
attachment r ecei v er plate. Check the
r ecei v er plate and clean it if necessar y .
Figure 14
1. Quick attach pins (shown
in engaged position)
3. Engaged position
2. Disengaged position
If y ou do not full y seat the quick attach
pins thr ough the attachment mount
plate, the attachment could f all of f of the
traction unit, cr ushing y ou or bystander s.
Ensur e that y our quick attach pins ar e
full y seated in the attachment mount
plate.
Connecting the Hydraulic Hoses
If the attac hment requires h y draulics for operation,
connect the h y draulic hoses as follo ws:
1. Stop the engine .
2. Mo v e the auxiliar y h y draulics lev er forw ard,
bac kw ard, and bac k to neutral to reliev e
pressure at the h y draulic couplers .
3. Mo v e the auxiliar y h y draulics lev er forw ard
into the detent position.
4. R emo v e the protecti v e co v ers from the
h y draulic couplers on the traction unit.
5. Ensure that all foreign matter is cleaned from
the h y draulic connectors .
22
To Next Page
Loading...
