Toro Dingo 220 - Page 27

V iscosity: See table belo w
F
5
-20 0 20
40 60
80 100
C
5
-30 -20 -10
0 10 20
30 40
USETHESESAEVISCOSITY OILS
32
10W-30
5W-20,5W-30
G000650
Figure 20
Changing the Oil and Filter
1. Star t the engine and let it r un for fiv e min utes .
T his w ar ms the oil so it drains better .
2. P ark the traction unit so that the drain side is
slightly lo w er than the opposite side to ensure
that the oil drains completely .
3. Lo w er the loader ar ms , c hoc k the wheels , stop
the engine , and remo v e the k ey .
Components will be hot if the traction
unit has been r unning . If y ou touch hot
components y ou may be bur ned.
Allo w the traction unit to cool bef or e
perf or ming maintenance or touching
components under the hood.
4. Place one end of a hose on the drain v alv e and
the other end in a pan ( Figure 21 ).
Figure 21
1. Oil drain valve
5. Open the drain v alv e b y tur ning it
countercloc kwise , pulling out as y ou tur n it
( Figure 21 ).
6. W hen the oil has drained completely , close the
drain v alv e and remo v e the hose .
Note: Dispose of the used oil at a cer tified
recycling center .
7. R emo v e the old filter and wipe the filter
adapter ( Figure 22 ) g ask et surface .
1
2
3
G000653
Figure 22
1. Oil lter 3. Adapter
2. Gasket
8. P our new oil of the proper type in through the
center hole of the filter . Stop pouring when
the oil reac hes the bottom of the threads .
9. Allo w a min ute or tw o for the oil to be
absorbed b y filter material, then pour off the
ex cess oil.
10. Apply a thin coat of new oil to the r ubber
g ask et on the re placement filter ( Figure 22 ).
11. Install the re placement oil filter to the filter
adapter . T ur n the oil filter cloc kwise until
the r ubber g ask et contacts the filter adapter ,
27