Toro GrandStand 74549 - Matching the Height-of-Cut

G015501
1
2
3
4
Figure90
60-inchmowerdecks
1.Adjustmentrods
3.Liftlink
2.Rearnuts4.Frontnuts
MatchingtheHeight-of-Cut
1.Checkthereartirepressure.
2.Settheheight-of-cuttothe7.6cm(3inches)position;
refertoAdjustingtheHeight-of-Cut(page25).
3.Withthemachineonlevelsurface,positiononeblade
front-to-rear.
4.MeasureatA,andfromalevelsurfacetothecutting
edgeofthebladetips(Figure91).
Note:Themeasurementshouldbe7.6cm(3inches).
Figure91
1.Measurefromalevel
surface
2.Measurethebladeatpoint
A
5.Ifitdoesnotmeasurecorrectly,locatetheheight-of-cut
rodontherightsideofthemachine(Figure92).
6.Adjusttheadjustmentboltuntilthebladetipsmatch
7.6cm(3inches)asshowninFigure92.
g015336
1
2
Figure92
1.Height-of-cutrod
2.Adjustmentbolt
58