Kickstand
Use the kickstand when you install or remove the transport wheels or the cutting unit.
G406964
CAUTION
The machine is heavy and can cause back strain if lifted improperly.
Put your foot pressure down on the kickstand and use only the lift-assist handle to
raise the machine. Attempting to raise the machine onto the kickstand any other way
can cause injury.
• T
RANSPORT-WHEEL-SERVICE position :
To use the kickstand to install the transport wheels, put your foot on the kickstand while
pulling up and back on the lift-assist handle
.
• S
TORAGE position :
1. Keep your foot on the kickstand while lowering the traction drum to the ground.
2. Remove your foot from the kickstand and allow space for the kickstand to retract to
the S
TORAGE position.
• C
UTTING-UNIT-SERVICE position :
To prevent the machine from tipping backward when removing the cutting unit, lower the
kickstand and push out the spring pin
so that it keeps the kickstand in position.
3460-887A Page 4–8 Product Overview: Controls
To Next Page
Loading...
