Toro GROUNDSMASTER 3000-D - Page 11

11
SET-UP INSTRUCTIONS
INSTALL FRONT & REAR WHEELS
1. Mount wheels and torque mounting nuts to 7580
ft-lbs (102108 Nm).
INSTALLING STEERING WHEEL (Fig. 1)
1. Move rear wheels so they point straight ahead.
2. Slide steering wheel assembly onto steering shaft.
Figure 1
1. Steering Wheel
2. Flat Washer
3. Nut
4. Cap
1
2
4
3
3. Secure steering wheel to shaft with flat washer and
nut. Tighten nut it to 10-15 ft-lb.
4. Install cap on steering wheel.
INSTALL ROLL BAR (Fig. 2)
Model 30302 only
1. Loosely mount a bar assembly to each end of roll
bar with (2) bolts and flatwashers.
2. Lower roll bar into frame holder, aligning mounting
holes as shown in Fig. 2.
3. Loosely secure bar assembly to frame holder with
(4) bolts and flat washers (Fig. 2).
4. Tighten all fasteners to 100 ft-lb..
Figure 2
1. Roll Bar
2. Bar Assembly
3. Frame Holder
1
2
3
GREASE TRACTION UNIT
Before the machine is operated, it must be greased to
assure proper operating characteristics; refer to
Lubrication Maintenance. Failure to grease the
machine will result in premature failure of critical parts.