35
HYDRAULIC SYSTEM MAINTENANCE
8. Start and run the engine at idle speed for about two
minutes and turn the steering wheel lock to lock to purge
air trapped in the system. Shut the engine off.
1
Figure 50
1. Drain plug
9. Leave machine set for two additional minutes, then
remove dipstick and check oil level in axle (Fig. 51). If
level is low, add oil until level matches groove in dipstick
(Fig. 51). If level is too high, remove drain plug (Fig. 50)
and drain oil until oil level matches groove in dipstick.
1
2
Figure 51
1. Dipstick 2. Groove
To Next Page
Loading...
