Toro Groundsmaster 4100-D - Adjustments; Wing Deck Position Switches

Groundsmaster 4100--D/4110--D Page 5 -- 19 Electrical System
Adjustments
Wing Deck Position Switches
Adjustment
1. Park machine on a level surface,lowercuttingdeck,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Remove switch cover from deck to allow access to
position switch that requires adjustment.
3. Raiseandlowerwingdeckwhilemonitoringthewing
deck latch and the position switch LED on cable end of
switch:
A. The position switch should open (switch LED is
not illuminated) when the wing deck link c auses the
wingdeck latch todisengageas wingdeckisraised.
B. The position switch should close (switch LED is
illuminated)whenthewingdecklinkcausesthewing
deck latch to engage as wing deck is lowered.
4. If necessary, adjust switch location to allow correct
operation:
A. Loosen jam nuts on switch and adjust switch
location to allow proper switch operation.
B. After switch adjustment, torque jam nuts from
165 to 195 in--lb (18.7 to 22.0 N--m).
C. Make sure that position switch does not contact
bolt head on wing deck link when wing deck is fully
lowered.
5. After testing iscomplete,make sure thatswitch con-
nectorispluggedintodeckwireharnessandswitchcov-
er is secured to deck.
1. Switch cover
2. Position switch
3. Switch bracket
4. Lock washer (2 used)
5. Jam nut (2 used)
Figure 13
1
2
3
4
5
1. Position switch
2. Bolt head
3. Wing deck link
Figure 14
1
2
3
Electrical
System