39
1
2
3
4
Figure 63
1. ACC fuse
2. Relay fuse
3. Deck fuse
4. Run fuse
ACC 5 amp.
Relay 5 amp.
Deck 30 amp.
Run 15 amp.
Pivoting (Tilting) the Cutting
Unit
Note: Although not required for normal maintenance
procedures, the cutting unit may be pivoted (tilted) to a
upright position. Should you desire to tilt the cutting unit,
use the following procedure:
Pivoting the Cutting Unit Upright
1. Drive machine onto ramps to raise front of machine.
2. Lower center and wing cutting units to the ground: then
raise center cutting unit slightly, until rear deck straps
hang freely on lift arm brackets. Stop engine after
cutting unit is raised. Set parking brake.
3. Disconnect the 3 hydraulic lines (quick couplers) and
wire harness at rear of deck (Fig. 64).
1
23
Figure 64
1. Hydraulic line couplers
2. Wire harness
3. Rear deck straps
4. Remove hairpin cotters and height-of-cut pins securing
rear deck straps to height-of-cut brackets on deck
(Fig. 64).
5. Start engine and lower center cutting unit to the ground.
Stop engine after cutting unit is lowered.
6. Remove socket head screws securing drive shaft yoke
gear box input shaft. Slide yoke off shaft (Fig. 65).
Danger
Do not start the engine and engage the PTO
switch when PTO shaft is not connected to
gear box on cutting unit. If engine is started
and PTO shaft is allowed to rotate, serious
injury could result.
1
2
Figure 65
1. Drive shaft yoke 2. Gear box input shaft
7. Sit on seat, start the engine and slowly raise the center
cutting unit allowing cutting unit to pivot upright. Stop
the engine and remove the key from the ignition switch.
To Next Page
Loading...
