Toro Network LTC Plus-to-Network VP

To Next Page

Turn o the power supply to the LTC Plus

satellite. Remove the cabinet’s front cover to

access the internal components. Disconnect

all cables labeled A through F from the timing

mechanism and the front distribution board.

Retain cables B, D, E and F for installation.

Cables A and C will no longer be required for

the conversion and should be sent back to Toro

for proper recycling or disposal procedures. See

Figure 1.

Open the cabinet’s top cover to access the

timing mechanism (TM). Remove the four

retaining screws from the TM and lift it out of

the cabinet. Remove the modem from the back

of the TM and retain it for installation. e

LTC Plus TM will no longer be required for the

conversion and should be sent back to Toro for

proper recycling or disposal procedures.

See Figure 2.

Disconnect the ex cables from the distribution

board on the front side of the cabinet. Detach

the output boards by removing the two retaining

screws. Retain all ex cables, screws and output

boards for installation. See Figure 3.

Figure 1 Figure 2 Figure 3

Disconnect the ex cable that connects the

distribution board to the pump/common

module on the front side of the cabinet. Detach

the pump/common module by removing the

three retaining screws and washers. Retain the

ex cable, screws, washers and pump/common

module for installation. See Figure 4.

Remove the three retaining screws from the

distribution board and detach it from the

backplate. Retain the screws for installation.

e LTC Plus distribution board will no longer

be required for the conversion and should

be sent back to Toro for proper recycling or

disposal procedures. See Figure 5.

NOTE

Only the front distribution board is

being replaced with a Network VP conversion

board. e rear distribution board (If

equipped) will communicate directly to the

Network VP conversion board.

Install the Network VP/VPE conversion board

onto the backplate. Use the three retaining

screws removed from the old distribution board

to secure. See Figure 6.

Figure 4 Figure 5 Figure 6

Network LTC Plus-to-Network VP/VPE

Conversion Kit Installation Instructions

Need help?

Do you have a question about the Toro Network LTC Plus-to-Network VP and is the answer not in the manual?

Summary

Initial Disassembly and Component Removal

Power Off and Cabinet Access

Turn off power, remove cabinet cover, and disconnect cables labeled A through F.

Timing Mechanism and Modem Removal

Remove the timing mechanism and its modem from the cabinet for conversion.

Distribution Board and Output Board Detachment

Disconnect flex cables from the distribution board and detach output boards.

Pump;Common Module Removal

Detach the pump/common module by removing retaining screws and washers.

Distribution Board Replacement

Remove the old distribution board and install the new Network VP/VPE conversion board.

Modem Identification and Installation

Identifying Your Modem Type

Determine modem type by sticker or presence of a serial port.

Installing 89-7519 Modem

Install the modem tray and slide the 89-7519 modem onto it, connecting the ribbon cable.

Installing 102-0104;102-8568 Modems

Install 102-0104/102-8568 modems onto the protective cover and connect ribbon cable.

Final Installation and Recycling

Connecting Network VP;VPE TM and Cables

Install the Network VP/VPE TM onto the satellite cabinet and connect all cable assemblies.

Recycling and Disposal Instructions

Instructions for sending old components to Toro for recycling or proper disposal.