To Next PageTo Next Page
Need help?Do you have a question about the Toro OSMAC G3 and is the answer not in the manual?
General| Brand | Toro |
|---|---|
| Model | OSMAC G3 |
| Category | Marine Radar |
| Language | English |
Accesses menus and settings from the home display.
Explains the function of Select, Up, Down, Left, and Right buttons.
Satellite waits for and executes radio commands from the central.
Executes scheduled and manual watering; ignores radio commands.
Disables all watering operations, scheduled or manual.
Adjusts the hour and minute parameters for the clock.
Selects between Am/Pm (12-Hour) or 24 Hrs format.
Sets the day, month, and year parameters.
Selects between MMDDYY or DDMMYY format.
Selects or edits a specific program (up to 12).
Adjusts the watering percentage from 10% to 250%.
Assigns specific days or intervals for watering.
Sets up to 24 start times for a program.
Assigns stations and their specific runtimes.
Sets the maximum number of stations active at once (up to 16).
Assigns a unique identification address to each satellite.
Selects or edits the radio frequency for communication.
Configures each station as an irrigation station or a switch.
Disables a station from activation indefinitely.
Sets a station to activate relays or other devices, not pump.
Indicates if a station is set to irrigate today.
Indicates if a station was activated today.
Indicates if a station watered the day before.
Selects from preprogrammed frequencies or edits custom frequencies.
Displays radio model, firmware, serial number, and RSSI.
Used for troubleshooting at the direction of Toro support.
Used for troubleshooting at the direction of Toro support.
Resets all radio communication parameters to factory defaults.
Manually starts a station or stations with a specified runtime.
Manually starts a scheduled program before its set start time.
Manually starts a scheduled program with a different runtime.
Monitors real-time radio page commands for troubleshooting.
Reviews all received radio page commands.
Duplicate of Radio Settings section, see page 12.
Sets/edits the satellite's address for communication.
Displays firmware version number and creation date.
Displays diagnostic codes encountered by the controller.
Displays real-time values like radio voltage, battery voltage, RSSI.
Tests controller outputs, including pump and stations.
Tests all OSMAC G3 stations sequentially.
