17
Operational Description
Disables all stations in all satellites (rain shutdown). Note: Satellite address number is not used
with 7543 or 7544 command codes. The station will not respond to any further commands until
enabled.
Enables operation of all stations in all satellites. See note above.
Sequentially syringes all stations for a set length of time; e.g., 7546 turns on all stations for the
predetermined number of 30 second intervals as defined in the syringe time.
Disables pump start.
Enables pump start to be assigned to a station; e.g., 8001 48 assigns pump start to station 48.
Disables operation and turns off all station in the satellite with sequential shutdown
Enables operation of all stations in the satellite
Changes the password; e.g., 8004 7531 6108 will change the factory default password (7531) to
6108.
Sets the syringe time in 30-second intervals; e.g., 8006 01 0100 (without a password) or 8006
pppp 01 0100 (with a password) sets the syringe time to 100 intervals (50 minutes). The number
of intervals must be given as four digits with leading zeros but can be no greater than 0255.
Sets the time-out limit in 30-minute intervals. This must be specified using four digits with leading
zeros and no greater value than 0255; e.g., 8006 02 0060 (without a password) or 8006 pppp 02
0060 (with a password) sets the time-out limit to 30 hours.
Enables/disables the password. Use 8007 03 01 to enable password protection or 8007 03 00 to
cancel password protection.
Password disable command. Cancel the requirement of entering the password for every entered
command.
Password enable command. After activation, all commands will require the password to be
entered.
Configures stations as switches. Stations can be specified individually and in combination with a
range of stations; e.g., 8008 01 12 50 - 60 configures stations 1, 12 and 50 through 60 as switch-
es.
Note: Only a single dash is used when entering a range of stations.
Configures stations for irrigation. Stations can be specified individually and in combination with a
range of stations; e.g., 8009 01 20 45 - 48 configures stations 1, 20 and 45 through 48 for irriga-
tion.
Resets EPROM to factory defaults.
SPECIAL COMMAND CODES
Sends command 752101 to place satellite address number xxx in test mode with station 01 active.
Sends command 752201 to satellite. Increments station number in test mode by one.
Sends command 752203. Shuts off current station being tested and increment last station by three
for new station to test.
Sends command 752301. Shuts off current station being tested and decrement station by one for
new station.
Sends command 752302. Shuts off current station being tested and decrement by two for new sta-
tion.
Sends command 7520 to the last satellite, removing it out of test mode.
Command Code
7543
7544
7546
8000
8001
8003 00
8003 01
8004
8006 01
8006 02
8006 03
8007 03 00
8007 03 01
8008
8009
8011
9 xxx 752101
1
13 or 103
2
22 or 202
0 7520 or 9 xxx
To Next Page
Loading...
Need help?
General
