Need help?Do you have a question about the Toro Power Throw 622 and is the answer not in the manual?
General| Clearing Width | 22 in |
|---|---|
| Chassis | Steel |
| Starting System | Recoil |
| Starter Type | Recoil |
| Engine | Toro Premium 4-cycle |
| Clearing Depth | 12 in |
| Throw Distance | 35 ft |
| Auger Type | Steel |
| Type | Single-stage |
| Intake Height (in) | 12 in |
Read manual, check controls, know stop procedures, keep others away, inspect area, check safety devices, wear proper clothing, eye protection, adjust skids, disengage controls, use grounded cord, fill fuel safely.
Remove tie straps, slide wheels outward, position left handle, align holes, secure with capscrews/washers, repeat for right side, reinstall wheels, pin through inner/outer axle holes.
Check oil level, change oil initially at 2 hrs, then 25 hrs/annually. Move to level surface, clean dipstick area, remove dipstick, pour 21 oz SAE 5W-30 or 10 oil.
Use clean, fresh lead-free gasoline (85+ octane). Purchase only 30-day supply. Never use methanol/gasohol with >10% ethanol. Fill outdoors, not indoors. Do not fill completely.
Overview of auger/impeller drive, traction control, speed selector, ignition switch, throttle, choke, primer, fuel shut-off valve, discharge chute control, and deflector handle.
Guides for starting the engine (including pre-checks, spark plug, throttle, choke, fuel valve, key) and stopping the snowthrower safely (release controls, slow throttle, remove key, wait for parts to stop).
Prepare fuel system (add stabilizer, run engine), remove spark plug, add oil to cylinder, pull starter slowly, lubricate, change oil, clean unit, touch up paint, tighten fasteners, store in clean, dry place away from ignition sources.
To Next Page