To Next PageTo Next Page
Need help?Do you have a question about the Toro Power TRX 1428 OHXE and is the answer not in the manual?
General| Clearing Width | 28 inches |
|---|---|
| Intake Height | 21 inches |
| Starting System | Electric Start |
| Drive System | Hydrostatic |
| Auger System | Anti-Clogging System (ACS) |
| Auger Material | Steel |
| Throw Distance | Up to 60 ft (18 m) |
| Speeds | Variable |
| Chute Control | Quick Stick |
| Impeller | 14 in (36 cm) Diameter |
| Tire Size | 16 in (41 cm) |
General safety precautions for operating the machine.
Details on safety decals and their locations on the machine.
Procedure to check the engine-oil level before operation.
Procedure to check the skids and scraper for proper operation.
Procedure to verify the proper functioning of the traction drive.
Instructions on how to extend the drift breakers.
Technical specifications of the snowthrower models.
Information on approved attachments and accessories for the machine.
Safety precautions to take before starting and operating the machine.
Important safety information regarding fuel handling and storage.
Step-by-step guide on how to safely fill the fuel tank.
Safety precautions to observe while operating the machine.
General safety guidelines to follow during machine operation.
Procedures for starting the engine using electric or recoil start.
Steps to properly shut down the engine.
Instructions on how to use the handwarmer feature.
How to adjust the auger housing height.
How to engage and control the machine's traction drive.
How to use wheel-clutch levers for steering and maneuvering.
How to select forward and reverse gears.
How to engage and disengage the auger and impeller.
Instructions for using the Quick Stick control.
Procedure for clearing a clogged discharge chute.
General tips for efficient and safe operation.
Schedule for routine maintenance tasks and intervals.
Safety precautions to follow before performing maintenance.
Steps to take before starting any maintenance procedure.
Procedure to check and adjust the engine oil level.
Procedure to check and adjust auger skids and scraper.
Procedure to check and adjust track skids.
Procedure to check and adjust track tension.
Procedure to check and adjust the traction cable.
Procedure to check and adjust the auger/impeller cable.
Procedure to check and add oil to the auger gearbox.
Procedure for changing the engine oil.
Procedure for replacing the spark plug.
Information on replacing drive belts.
Procedure for replacing the headlight assembly.
Safety precautions for storing the machine.
Steps for properly storing the machine for extended periods.
Procedure for taking the machine out of storage.
Troubleshooting steps for when the electric starter does not engage.
Troubleshooting steps for engine starting issues.
Troubleshooting steps for rough engine operation.
Troubleshooting for poor snow discharge performance.
Troubleshooting for discharge chute latch or movement issues.
Troubleshooting for improper snow clearing.
