Toro ProStripe 560 Installation Instructions

2. Move the machine to a level surface, ensure that
the engine is shut of f, and wait for all moving
parts to stop.
3. Disconnect the spark-plug wire from the spark
plug; refer to the Operator ’ s Manual for your
machine.
For the eProStripe 560 60V mower:
1. Move the machine to a level surface, shut of f the
machine, and wait for all moving parts to stop.
2. Remove the electric-start button and all battery
packs from the machine.
2
Assembling the Brush
Mount
Parts needed for this procedure:
1 Brush-adjustment bracket
1
Groomer brush
4
Capscrew (8 x 60 mm)
8
W asher (8 mm)
4
Locknut (8 mm)
2 Brush-height plate
2
Carriage bolt (8 x 25 mm)
2 Knob
2
Strut (brush)
2
Capscrew (6 x 20 mm)
4
W asher (6 mm)
2
Locknut (6 mm)
Assembling the Groomer Brush to
the Brush-Adjustment Bracket
g284576
Figure 1
1. Capscrew (8 x 60 mm) 4. Locknut (8 mm)
2. W asher (8 mm) 5. Groomer brush
3. Brush-adjustment bracket
1. Align the holes in the brush-adjustment bracket
with the holes in the groomer brush as shown
in Figure 1 .
2. Assemble the brush-adjustment bracket to the
groomer brush ( Figure 1 ) with 4 capscrews (8
x 60 mm), 8 washers (8 mm), and 4 locknuts
(8 mm).
3. T ighten the capscrews and locknuts.
Assembling the Brush-Adjustment
Bracket to the Brush Mount
1. Assemble the brush and brush-adjustment
bracket to the brush mount as shown in Figure 2 .
Note: Ensure that the rod ends of the handle
for the brush-adjustment bracket align through
the slots in the brush mount.
3

Toro ProStripe 560 Specifications

General

Brand	Toro
Model	ProStripe 560
Category	Lawn Mower
Language	English