Toro Recycler 20332C - Adjusting the Cutting Height; Cutting Height Adjustment Procedure; Starting the Engine; Engine Start Procedure

AdjustingtheCuttingHeight
WARNING
Adjustingthecuttingheightmaybringyouinto
contactwiththemovingblade,causingserious
injury.
•Stoptheengineandwaitforallmovingparts
tostop.
•Donotputyourngersunderthehousingwhen
adjustingthecuttingheight.
CAUTION
Iftheenginehasbeenrunning,themuferwillbe
hotandcanseverelyburnyou.Keepawayfromthe
hotmufer.
Adjustthecuttingheightasdesired.Setthefrontwheels
tothesameheightastherearwheels(Figure9).
Note:Toraisethemower,movethefrontcutting
heightleversrearwardandtherearcuttingheightlevers
forward.Tolowerthemower,movethefrontcutting
heightleversforwardandtherearcuttingheightlevers
rearward.
Figure9
1.Raisethemower2.Lowerthemower
Note:Thecuttingheightsettingsare1inch(25mm);
1-3/8inches(35mm);1-3/4inches(44mm);2-1/8
inches(54mm);2-1/2inches(64mm);2-7/8inches(73
mm);3-1/4inches(83mm);3-5/8inches(92mm);and
4inches(102mm).
StartingtheEngine
1.Holdthebladecontrolbaragainstthehandle
(Figure10).
Figure10
1.Bladecontrolbar
2.Turntheignitionkey(Figure11)(electric-start
modelsonly)orpulltherecoilstarthandle
(Figure12).
Note:Whenyoupulltherecoilstarthandle,pullit
lightlyuntilyoufeelresistance,thenpullitsharply
(Figure12).Allowtheropetoreturntothehandle
slowly.
Figure11
8