Toro SMRT Logic - Adding a Controller; Add Irrigation Controller; Setting an Irrigation Schedule; General Schedule Settings

3
Adding a Controller Setting an Irrigation Schedule
4 5
Add Controller to the SMRT Logic
Multiple irrigation / lighting controllers can be added
to a location. Controllers must be added one at a
time.
1. Click Irrigation tab then Controllers.
Click + Add Controller button.
2. Select the controller from the dropdown list.
For the Quick Start, we will be adding an
EVOLUTION controller to the location.
3. Enter a name and description for the controller.
4. For the Smart Connect™ ID, go to the
EVOLUTION controller, to ADVANCED ->
SENSORS -> SMART CONNECT. The ID will be
visible at the SMART CONNECT screen.
Enter it into the eld.
5. Press Add. The controller will be added with a
default irrigation schedule already congured.
Schedules
1. Click the Schedules tab.
Click the white gear icon for the desired
schedule or program.
2. In the Edit Schedule A screen, it is possible to
change the description, select the days of week
to water, select start times, add sensors, and
more.
Above, the controller is set to irrigate on
Mondays, Wednesdays, and Fridays with a
start time of 6am. A rain sensor is added to the
schedule and there is a ten second delay between
when one zone stops and the next starts.
3. Switch to the Zones tab
(adjacent to the General tab under Schedules).
4. Add zones to the specied schedule. From the
dropdown list of zones, select a zone to add to
the schedule and click Add Zone.