4
5. Repeat step 4 to add all desired zones to the
selected schedule. Below, we have added 4
zones to the schedule.
6. Next, set runtimes for each zone. Simply click
inside the Runtime eld and click the up and
down arrows to adjust the runtime for hours and
minutes.
4 zones added.
Zone runtimes have all been set to 10
minutes.
For Quick Start purposes, we are done.
For complete details on editing schedules,
such as MV/Pump Delay, Cycle Time, Soak
Time, and Advanced Settings, please see
the documentation for your controller.
To Next Page
Loading...
