Fuel can be left in gas tank only if a fuel additive,
such as Toro's Stabilizer/Conditioner, is added to
gasoline before storing. Toro's Stabilizer/Conditioner
is a petroleum distillate based conditioner/stabilizer.
Toro does not recommend stabilizers with an alcohol
base, such as ethanol, methanol or isopropyl. Use fuel
additive in recommended quantities as specified on
container.
Engine
1. While engine is still warm, drain oil from
crankcase. See Maintenance chapter, Change
Engine Oil section.
2. Remove spark plug. Using an oil can, squirt
about one tablespoon of oil through spark plug
hole.
3. Slowly rotate engine several times, using starter
rope, to distribute oil.
4. Reinstall spark plug but DO NOT connect spark
plug wire.
.
.
Lubricate the wheels. See Maintenance chapter,
Lubrication section.
Charge battery. See Maintenance chapter,
Charging Battery section.
5. Touch up all rusted or chipped paint surfaces.
Removing From Storage
1,
2.
Check and tighten all fasteners.
Remove spark plug and spin engine rapidly
using starter to blow excess oil from the
cylinder. Clean spark plug or replace if cracked,
broken or electrodes are worn.
3. Install spark plug and torque to 15 ft.-lbs.
(20 N.m).
4. Perform recommended maintenance procedures.
See Maintenance section.
5. Fill fuel tank with fresh, clean gasoline.
6. Check engine oil level.
7. Reconnect spark plug wire.
Cleaning
,
,
3,
Clean mower. See Maintenance chapter,
Cleaning section.
Clean dirt and chaff from cylinder, cylinder head
fins, and blower housing. Also remove grass
clippings, dirt, and grime from external parts of
the engine, shrouding, and top of mower
housing.
Clean air filter, See Maintenance chapter, Air
Filter section.
General
1. Check condition of blade. See Maintenmlce
chapter, Blade section.
2. Tighten all nuts, bolts, and screws.
Accessories
For special conditions, the following accessories may
be purchased at your local Authorized Toro Service
Dealer.
.
,
.
Rear Bag Kit,
Model No, 59192 for hand push models,
Model 59195 for self-propelled models-
Install discharge tunnel and rear mounting grass
bag to convert Recycler ® mower to a rear
bagging mower (Fig. 33). lncludes discharge
tunnel plug.
Grass Bag, Model No. 59296 -- Rear mounted
for bagging long grass, lush grass or leaves.
Side Discharge Kit, Model No. 59197--Installs
in seconds. Rear mounted in place of the grass
bag or discharge tunnel plug. Disperses clippings
while trimming on both sides (Fig. 34).
EN-20
To Next Page
Loading...
