Toro TimeCutter MX 4275T - User Manual

Toro TimeCutter MX 4275T

60 pages

To Next Page

To Next Page

Loading...

FormNo.3433-820RevB

TimeCutter

®

MX4275Tand5075T

RidingMower

ModelNo.74690—SerialNo.400000000andUp

ModelNo.74694—SerialNo.400000000andUp

Registeratwww.Toro.com.

OriginalInstructions(EN)

*3433-820*

Table of Contents

Other manuals for Toro TimeCutter MX 4275T

Manual240 pages

Questions and Answers:

A
Aimee ReidAug 21, 2025
Why won't my Toro TimeCutter MX 4275T Lawn Mower engine start?
- C
  Colin PadillaAug 21, 2025
  If your Toro Lawn Mower engine won't start, starts with difficulty, or stalls, several factors could be at play. Make sure the fuel tank isn't empty by filling it. If your model has a choke, ensure it's turned on. A dirty air cleaner can also cause issues, so clean or replace it. Check the spark plug wire(s) to ensure they are correctly connected, and inspect the spark plug(s) for damage or incorrect gap, replacing if necessary. Also, ensure that the fuel filter is clean, and the fuel tank has the correct fuel type. Finally, check the oil level and add oil if it's low.
J
justin45Sep 3, 2025
Why is my Toro TimeCutter MX 4275T Lawn Mower losing power?
- P
  Peter WestSep 3, 2025
  Your Toro Lawn Mower may be losing power for several reasons. The engine load could be excessive, so reduce the ground speed. A dirty air cleaner can cause power loss, so clean it. Check the oil level in the crankcase and add oil if low. Also, inspect the cooling fins and air passages under the engine blower housing for obstructions and remove them. Replace the spark plug(s) if they are pitted, fouled, or have an incorrect gap. For issues like a blocked fuel-tank vent, dirt, water, or stale fuel in the fuel system, or incorrect fuel, contact an Authorized Service Dealer. If there is dirt in the fuel filter, replace it.
L
Leonard JacksonSep 1, 2025
How to fix uneven cutting height on my Toro TimeCutter MX 4275T?
- C
  Christine FrazierSep 1, 2025
  Uneven cutting height on your Toro Lawn Mower can be caused by several factors. Start by sharpening the blade(s). If a cutting blade(s) is/are bent, install a new cutting blade(s). Ensure the mower is level from side-to-side and front-to-rear. If applicable, check that the anti-scalp roller is set correctly and adjust the anti-scalp wheel height. Clean the underside of the mower deck. Adjust the tire pressure.
S
Samantha AguilarAug 30, 2025
Why is my Toro TimeCutter MX 4275T Lawn Mower engine losing power?
- M
  millerjoshuaAug 31, 2025
  A loss of power in your Toro Lawn Mower engine can stem from several causes. Check if the engine load is excessive and reduce the ground speed if needed. Ensure the air cleaner is clean; if it's dirty, clean it. Verify the oil level in the crankcase and add oil if it's low. Clear any obstructions from the cooling fins and air passages under the engine blower housing. Inspect the spark plug(s) for pitting, fouling, or an incorrect gap, and replace it if necessary. Check the fuel filter for dirt and replace it if needed.
J
jsantiagoAug 29, 2025
How to fix a Toro TimeCutter MX 4275T engine that loses power?
- O
  odompeterAug 29, 2025
  If your Toro Lawn Mower engine is losing power, consider these potential causes. The engine load might be too high, so reduce your ground speed. A dirty air cleaner can also cause power loss, so clean it. Check the oil level in the crankcase and add oil if necessary. Also, remove any obstructions from the cooling fins and air passages under the engine blower housing. Finally, inspect the spark plug(s) and replace if pitted, fouled, or incorrectly gapped.
M
melody07Aug 27, 2025
What to do if my Toro TimeCutter MX 4275T starter does not crank?
- K
  Kathleen ThompsonAug 28, 2025
  If the starter on your Toro Lawn Mower isn't cranking, there are a few things to check. Ensure the blade-control switch is disengaged and that the motion-control levers are in the PARK position. A dead battery could also be the culprit, so try charging it. Additionally, inspect the electrical connections for any corrosion or looseness, and replace the fuse if it's blown.
A
Andre AdamsAug 26, 2025
Why is my Toro TimeCutter MX 4275T Lawn Mower cutting height uneven?
- O
  Omar MartinAug 26, 2025
  Uneven cutting height on your Toro Lawn Mower can result from several issues. The blade(s) may not be sharp, so sharpen them. If a cutting blade(s) is/are bent, install a new one. Ensure the mower is level from side-to-side and front-to-rear. If applicable, adjust the anti-scalp wheel height. Clean the underside of the mower deck if it's dirty. Adjust the tire pressure to the correct level. If a blade spindle is bent, contact an Authorized Service Dealer.
C
codylaraAug 25, 2025
What to do if my Toro TimeCutter MX 4275T engine does not start?
- E
  Eric HubbardAug 25, 2025
  If your Toro Lawn Mower engine doesn't start, starts hard, or fails to keep running, there are several possible causes. First, check if the fuel tank is empty and fill it if necessary. If your model has a choke, make sure it's on. A dirty air cleaner can also cause issues, so clean or replace it. Ensure the spark-plug wire(s) are properly connected. Inspect the spark plug(s) for damage or incorrect gap and replace if needed. Check for a dirty fuel filter and replace it. If there is dirt, water, or stale fuel in the fuel system, or if you're using incorrect fuel, contact an Authorized Service Dealer. Finally, check the oil level in the crankcase and add oil if it's low.
A
Adrian HenryAug 23, 2025
Why does my Toro Lawn Mower engine not start, start hard, or fail to keep running?
- J
  james61Aug 23, 2025
  Several factors can cause this issue. First, ensure the fuel tank isn't empty; if it is, fill it. If your model has a choke, make sure it's on. Check the air cleaner and replace or clean it if it's dirty. Ensure the spark plug wire(s) are securely connected to the spark plug. Inspect the spark plug(s) for pitting, fouling, or incorrect gap, and replace if necessary. Check the fuel filter for dirt and replace it if needed. Also, ensure that you have the correct fuel type in the fuel tank. Finally, verify that the oil level in the crankcase is sufficient and add oil if it's low.

Toro TimeCutter MX 4275T Specifications

General

Cutting Width	42 inches
Transmission	Hydrostatic
Fuel Capacity	3 gallons
Speed	Up to 7 mph
Warranty	3 years
Deck Material	Steel
Blade Tip Speed	18, 500 FPM
Spindle Material	Aluminum
Cutting Height	1.5 - 4.5 inches

Related product manuals

Preview: Toro TimeCutter MX 4260

Toro TimeCutter MX 4260

Preview: Toro TimeCutter MX 4250

Toro TimeCutter MX 4250

Toro TimeCutter MX 4200

Toro TimeCutter MX 5075

Preview: Toro TimeCutter MX 5025

Toro TimeCutter MX 5025

Toro TimeCutter MX 5050

Toro TimeCutter MX 5000

Toro TimeCutter MX 3450

Toro TimeCutter MX 6050

Toro TimeCutter MX 5075T

Preview: Toro TimeCutter MX 3450 74750

Toro TimeCutter MX 3450 74750

Preview: Toro TimeCutter MyRIDE

Toro TimeCutter MyRIDE