EasyManua.ls Logo

Toro TimeCutter MX4275 - User Manual

Toro TimeCutter MX4275
52 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
FormNo.3441-410RevB
TimeCutter
®
MX4275Riding
Mower
ModelNo.75747—SerialNo.400000000andUp
ModelNo.75747TA—SerialNo.400000000andUp
ModelNo.75747W—SerialNo.400000000andUp
Registeratwww.Toro.com.
OriginalInstructions(EN)
*3441-410*

Table of Contents

Questions and Answers

  • J
    Jordan WallaceAug 13, 2025
    Why won't my Toro TimeCutter MX4275 Lawn Mower engine start?
    • J
      jennifer82Aug 13, 2025
      Your Toro Lawn Mower engine might not start due to several reasons. First, ensure the fuel tank isn't empty by filling it. If it has fuel, check if the choke is properly engaged. A dirty air cleaner can also prevent starting, so clean or replace it. Make sure the spark plug wire is securely connected. The spark plug itself might be faulty, so consider replacing it with a new, correctly gapped one. Also, inspect the fuel filter for dirt and replace if necessary. Low oil level can also be the culprit, so add oil to the crankcase.
  • D
    dylanlewisAug 17, 2025
    Why is my Toro TimeCutter MX4275 Lawn Mower engine losing power?
    • R
      Robert RoseAug 17, 2025
      Your Toro Lawn Mower engine may be losing power for a few reasons. An excessive engine load could be the cause, so reduce the ground speed. A dirty air cleaner can restrict airflow, so clean it. Low oil level in the crankcase can also lead to power loss, so add oil. Check the cooling fins and air passages under the engine blower housing for any obstructions and remove them. A faulty spark plug(s) can also cause power loss, so install a new, correctly gapped spark plug(s). Replace the fuel filter if it's dirty.
  • M
    misty38Aug 20, 2025
    How to fix abnormal vibrations in my Toro TimeCutter MX4275?
    • M
      Mason MillerAug 20, 2025
      Abnormal vibrations in your Toro Lawn Mower can stem from several sources. Start by checking the cutting blades for bending or imbalance; replace them if necessary. Ensure the blade mounting bolt is tightened securely. Next, verify that the engine mounting bolts are also tight. Additionally, check the engine pulley, idler pulley, or blade pulley for looseness and tighten the appropriate pulley.
  • D
    David WilliamsAug 25, 2025
    Why is the cutting height uneven on my Toro Lawn Mower?
    • N
      nashtaraAug 25, 2025
      Uneven cutting height on your Toro Lawn Mower can be caused by several factors. Start by sharpening the blades. Bent cutting blades can also cause this issue, so replace them if necessary. Ensure the mower is level from side-to-side and front-to-rear. Check the anti-scalp roller setting and adjust the anti-scalp wheel height. Clean the underside of the mower deck. Finally, verify and adjust the tire pressure.
  • B
    Benjamin JuarezAug 28, 2025
    What to do if my Toro Lawn Mower doesn't drive?
    • F
      francisco03Aug 28, 2025
      If your Toro Lawn Mower isn't driving, check if the bypass valves are open and close the tow valves.
  • D
    David MooreSep 1, 2025
    What to do if my Toro TimeCutter MX4275 engine overheats?
    • S
      Sandy BarrettSep 1, 2025
      If your Toro Lawn Mower engine is overheating, there are several possible causes. First, the engine load may be excessive, so reduce the ground speed. Check the oil level in the crankcase and add oil if it is low. Also, inspect the cooling fins and air passages under the engine-blower housing for obstructions and remove them. A dirty air cleaner can also cause overheating, so clean or replace the air-cleaner element.
  • E
    Eric MendozaSep 4, 2025
    What to do if the starter on my Toro TimeCutter MX4275 Lawn Mower won't crank?
    • B
      bsimonSep 4, 2025
      If the starter on your Toro Lawn Mower isn't cranking, several issues could be the cause. Ensure the blade-control switch is disengaged. Also, make sure the motion-control levers are in the PARK position. A dead battery can prevent cranking, so charge the battery. Check the electrical connections for corrosion or looseness, and ensure they have good contact. Lastly, inspect the fuse and replace it if blown.
  • J
    John JohnsonSep 8, 2025
    What to do if the blades on my Toro TimeCutter MX4275 Lawn Mower do not rotate?
    • G
      gjonesSep 8, 2025
      If the blades on your Toro Lawn Mower aren't rotating, it could be due to a worn, loose, or broken drive belt, so install a new drive belt. It's also possible that the drive belt has come off the pulley, so install the drive belt and check the adjusting shafts and belt guides for the correct position. Another possibility is a worn, loose, or broken mower belt, so install a new mower belt.

Toro TimeCutter MX4275 Specifications

General IconGeneral
Cutting Width42 inches
Fuel Capacity3 gallons
Blade Tip Speed18, 000 FPM
Ground Speed Forward7 mph
Ground Speed Reverse3 mph
Cutting Height1.5 - 4.5 inches
Warranty3 years
TransmissionHydrostatic
Deck MaterialSteel
Seat TypeHigh back
Tires Front11 in x 4 in - 5 in (28 cm x 10 cm - 13 cm)

Related product manuals