Moving a Non-Functioning Machine (continued)
5. Disengage the parking brake by moving both motion-control levers down to the center,
unlocked position.
Note: Do not start the machine.
6. Move the machine as required.
IMPORTANT
Always push the machine by hand. Do not tow the machine, because towing may
damage it.
7. Move the motion-control levers outward to the P
ARK position.
8. Move both bypass levers rearward and over through the slotted hole to lock them in
place
.
Raising the Machine
Use jackstands to support the machine when you raise it.
WARNING
Supporting the machine on the lower muffler shield may damage the shield and
cause the machine to fall, injuring you or bystanders.
Do not use the lower muffler shield to lift or support the machine.
G451399
3466-517A Page 5–4 Maintenance: Pre-Maintenance Procedures
To Next Page
Loading...
