XL GEAR DRIVE
2 - 18 XL Lawn Tractor Service Manual
10. Reinstall the idler spring on bolt holding the idler
pulley to the idler assembly (Figure 64).
Figure 64
mvc-000a
11. Adjust both the right and left engine belt guides so
they are within 1/8” (3mm) of the engine pulley
(Figure 65).
Figure 65
mvc-000E
12. Install rear hitch plate and seat springs (Figure
66).
Figure 66
mvc-0037
13. Install battery and battery tray. Note: If battery
uses a battery drain tube, make sure the tube
is reinstalled through the rear hole in the
frame (Figure 67). Connect the battery cables.
Figure 67
mvc-639
14. Reinstall the mower deck (refer to “Mower” section
on page 6 - 1).
15. Test operate the tractor to make sure the unit
shifts, brakes, and shifts on-the-go properly. Test
the safety interlock system.
1/8” (3mm)
To Next Page
Loading...
