XL Lawn Tractor Service Manual 3 - 9
XL HYDROSTATIC TRANSAXLES
9. Reconnect the idler spring to the idler bracket
assembly (Figure 93).
Figure 93
MVC-001C
10. Adjust and tighten the right and left engine belt
guides so the guides are within 1/8” (3mm) of the
belt and pulley (Figure 94).
Figure 94
MVC-001F
11. Adjust and tighten the right and left rear transaxle
belt guides. Adjust the guides so they are within
1/8” (3mm) of the belt and pulley (Figure 95).
Figure 95
MVC-0039
12. Install the rear hitch plate. There are 2 bolts,
washers, and nuts on each side of the plate and 2
bolts, washers, and nuts for the seat springs
(Figure 96).
Figure 96
MVC-0037
1/8” (3mm)
1/8” (3mm)
To Next Page
Loading...
